fiar na madeira

spinning in Madeira

Na Madeira, subimos do Funchal por dentro de uma névoa cerrada em direcção a Ribeiro Frio. Íamos ao encontro (com ajuda dos amigos) da D. Maria Isabel, que faz barretes de vilão com a lã das suas ovelhas, que são – julgo eu – da raça churra madeirense (só vi a raça referida aqui e não vem mencionada no meu site de referência habitual). Neste vídeo, a D. Isabel descreve a tosquia e a lavagem da lã.

Ver como se fia num sítio novo é quase sempre ocasião para surpresas. Já fora assim na ilha do Pico, onde vi fiar com um fuso leve e esguio apoiado numa cadeira, e assim foi também desta vez. O fuso da D. Maria Isabel, feito em urze, era longo e pesado, sem o sulco helicoidal (a rosca no topo da haste) habitual nos fusos portugueses. O fuso é apoiado no chão e a lã é preparada para a torção num movimento cuidado dos dedos da mão esquerda sobre o joelho (segundo vídeo). Este outro vídeo mostra o processo de torcer dois fios juntos para criar o grosso fio retorcido que é usada nos barretes. Como diz a D. Isabel, não é que seja coisa reles de fazer, mas dá um pedaço de trabalho.

We left Funchal towards the mountains and through thick fog. We were going to Ribeiro Frio to meet D. Maria Isabel, spinner and maker of the traditional knitted hats stil worn by some farmers and shepherds. The first video above shows D. Isabel with her wool carders describing the process of shearing and scouring the local wool – two tasks which are still done entirely by hand.

Seeing how hand spinning is done in a place I have never visited before is always a time for surprises. In Pico island we saw a woman spinning on a supported spindle, something I had never witnessed in Portugal before. The spindle from Pico was short and made from a lightweight wood, very unlike the one used by D. Isabel: this one, made of heather wood, was long and heavy and rested directly on the ground. Unlike most portuguese spindles, it didn’t have the screw-shaped incision along the top section of the shaft. The carded wool is held in the left hand (as usual) and the drafting is carefully done on the knee, a detail which was also new to me (second video above). This video shows the process of plying two strands of yarn together (rotating the same spindle counterclockwise) to create the thick 2ply used to knit the hats.

spinning in Madeira

Comments

2 responses to “fiar na madeira”

  1. Alessandra Avatar

    Estes vídeos são lindos, lindos! Uma riquesa para os dias de hoje!

  2. […] O tipo 2 compreende os fusos em que a haste de madeira é o elemento principal ou único. Podem ser bastante rudes ou muitíssimo delicados, podem ser pouco mais do que um pau ou ser elegantemente bojudos em baixo […]

Leave a Reply to Alessandra Cancel reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.